Multi-stage furnaces are premium furnaces. Their efficiency (AFUE) is typically above 94%, and they are able to extract heat from the exhaust gases, by reusing them (they are of condensing type).
Better Air Quality
Better Quality Control
Perfect for zoning
80% Furnaces are
Cost-effective in milder climates
Less expensive than condensing gas furnaces
May be best for high-performance homes
Ductless Mini Split
Split-ductless systems are ideal for cooling or heating single rooms that get used, but not all the time. Rather than cranking the thermostat up or down to reach a single room, ductless systems can be used to achieve comfort in those spaces only when they are occupied by installing a system in the spaces needed to be . If no one is in the room, there is no need to pay to cool or heat that area.
High season energy efficiency ratio Condensers can range up to 26 Seer. The higher the SEER the quieter the unit. They can save you money on your PG& E. They offer Lifetime compressor limited Warranty, 10 year unit replacement limited warranty and 10 year parts limited warranty.
Electric heat pumps provide an efficient system for heating and cooling your home. During colder seasons, it provides warmth not by convert electricity directly into heat, but rather by absorbing the heat from the atmosphere or ground, multiplying it and then transferring heat to the home.
Single stage season energy efficient ratio condensers are quiet units. They may cost less than the higher seer multistage condensers but they are effective and efficient enough to do the job of
Package Unit Installation
Packaged units are space-efficient, with all components of the heating and cooling system located in one place; they are well-suited to homes without an attic or basement. The entire unit is assembled in a controlled environment, and most units come charged with refrigerant. And because it is a single unit and pre-charged with refrigerant, installation of a packaged unit can be less expensive than a split system.
Packaged Heat Pumps: The heat pump transfers heat by reversing the refrigeration cycle used by a typical air conditioner. Through a cycle of evaporation and condensation, the indoor coils are heated, and the air is pushed over the warm coils. From there, the warmed air is blown through the ductwork to increase the temperature in the interior rooms of your home.
The best ways to be sure your heating system is performing to its full potential is with an annual furnace tune-up, cleaning and safety check. Our skilled technicians will keep you system operating at its full potential by helping to prevent service calls down the road, while boosting indoor air quality and energy efficiency. Because your safety is our highest priority, we check for gas leaks and carbon monoxide levels
RLP Mechanical HVAC maintenance checklist:
Clean evaporator and condenser air conditioning coils. Dirty coils reduce the system's ability to cool your home and cause the system to run longer, increasing energy costs and reducing the life of the equipment.
Check your central air conditioner's refrigerant level and adjust if necessary. Too much or too little refrigerant will make your system less efficient increasing energy costs and reducing the life of the equipment.
Clean and adjust blower components to provide proper system airflow for greater comfort levels. Airflow problems can reduce your system's efficiency by up to 15 percent.
Check all gas (or oil) connections, gas pressure, burner combustion and heat exchanger. Improperly operating gas (or oil) connections are a fire hazard and can contribute to health problems. A dirty burner or cracked heat exchanger causes improper burner operation. Either can cause the equipment to operate less safely and efficiently.